Page 39 - Carmex - Tiny Tools 2020

®
Tiny Tools

General instructions for use

The CIM tool holder system is design for a fast and simple way of achieving correct indexing of Tiny Tools
inside the machine.

Following is a recommended procedure for the first use:

1. Adjust the rear stopper screw according the tool required over-hang.
Insert the Tiny Tool into the collet and push it gently until it passes the internal indexing mechanism.
Adjust the rear stopper screw according the required overhang (do not set the final tool orientation).
That procedure should be done only once and outside the machine.

2. Remove the Tiny Tool from the CIM tool holder and mount the holder on the machine.
Clamp it well and it is ready to use. At that point the clamping nut should be screwed on the tool
holder collet by hand and remain open.

3. Insert the Tiny Tool into the CIM collet and push it inside gently until you will hear a click.
Rotate the tool by hand clock wise and counter clock wise until you hear a click and the indexing
mechanism set the tool to center.
4. Close the nut by the wrench key.

In that point the tool is ready to use.
For a tool replacement, open the collet with the wrench key, replace the tool, close the collet and continue
working.

39